ENSONIQ ASR-10 Spécifications Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 154
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
I
~~
Instrument, Bank
&
Preset Parameters
1
Layer Limitations
The ASR-10 uses different layers to separate stereo data, and/or velocity switched data. Both the
Akai and Roland architectures allow for situations that can cause the ASR-10 to run out of layers
before completing an import, even though there may be enough memory to load in the waveform
data. It is also possible that samples will be placed in a layer that has a slightly different velocity
range than the original Akai or Roland program.
Akai
The Akai architecture allows you to stack or velocity cross-switch up to 128 wavesamples on a
single key. The ASR only allows 8 layers (4 stereo) per instrument. Although it is somewhat rare,
there are some Akai programs that require more than 8 layers for the conversion.
Roland
The Roland architecture allows you to create velocity splits at the Partial level. This results in the
possibility of having more than 8 different velocity split values in a given instrument, exceeding
the number of layers in the ASR-10.
In both cases, the conversion process deals with this the best that it can, but eventually runs out
of layers for the instrument. This situation will result in the “IMPORT INCOMPLETE” message,
followed by “NO MORE LAYERS”. Use of the import key range will reduce the chance of
exhausting all layers in the program. The selection of a limited key-range will cause the ASR-10
to only look at the layer needs for that range, as opposed to the whole instrument. In this way
you can “break-up” the import across several Instruments, and better match the original velocity
split values.
What follows are symptoms of this “NO MORE LAYERS” scenario. In all cases, you should
import by key range for better results.
l A sound does not play across its full velocity range
l A cross-switched sound is missing a velocity range element (a 3 way snare only has 2
samples present)
l From sample to sample the velocity cross-switch performance does not match up (e.g., a pop
for a slap bass is not even across the keyboard)
l An element is missing from a sound (Guitar
&
Strings does not have the Strings element)
14
ENSONIQ ASR-10 Version 3 Operating System
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 153 154

Commentaires sur ces manuels

Pas de commentaire