ENSONIQ ASR-10 Spécifications Page 53
- Page / 154
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Audio Track Recording
SteP
Two: Configuring Audio Tracks for
RAMTrack
or DiskTrack Recording
These procedures configure the Audio Tracks for either RAM or SCSI recording and playback, or
completely disable Audio Track recording and playback.
How to Configure the ASR-10 for RAMTrack recording:
1.
Press
(m),
then (SYSTEM-MIDI], and use the Data Entry Controls to select the
CONFIGURE AUDIO TRACKS command:
SYSTEM STOP
2.
On this page, press (ENTER-YES). The display shows:
I
RTRK
PLRYIREC=RR?i
I
3.
Use the Data Entry Controls to set ATRK PLAY /REC=RAM (the default setting). When
ATRK PLAY /REC=RAM, entering record with an Audio Track solidly selected
wilI
record
AudioSamples into RAM on the solidly selected Audio Track. This is the default setting for
the CONFIGURE AUDIO TRACKS Command.
4.
Press (ENTER-YES) again. The display will momentarily show COMMAND COMPLETED,
and you will be returned to the CONFIGURE AUDIO TRACKS command page.
How to configure the ASR-10 for
DiskTrack
recording:
1.
Make sure that the ASR-10 and the SCSI storage device are both powered down, then connect
the external SCSI storage device to the SCSI Connector on the rear panel of the ASR-10 as
shown in the SCSI connection diagram earlier. For more information about using SCSI with
your ASR-10, refer to the section about the SP-3 SCSI Interface.
2 Turn on the ASR-10 and the SCSI storage device.
3.
Press
(m),
then (SYSTEM-MIDI), and use the Data Entry Controls to select the
CONFIGURE AUDIO TRACKS command:
SYSTEM STOP
COI‘1FIGURE
RUCIO
TRRCKS
4.
On this page, press the (ENTER-YES) button, and set ATRK PLAY/REC=SCSI:
I
SYSTEM
',<
,F
-_j.j
STOP
I
RTRK
P:RY/REC=SL-SI
5.
With the above screen set to ATRK
PLAY/REC=SCSI,
pressing (ENTER-YES) will display the
ENSONIQ ASR-10 Version 3 Operating System
43
- ENSONi’a]‘” 1
- READ THIS FIRST! 2
- Advanced Sampling Recorder 3
- Version 3 Operation System 3
- Table of Contents 5
- Troubleshooting 8
- List of Tips 10
- What’s New in 3.0 11
- What’s New in 2.5 11
- What’s New in 2.0 11
- What’s New in 1.5 12
- Backing Up the O.S. Disk 13
- Introduction 14
- New Command/Instrument Pages 15
- How To Import Akai Samples 16
- LOAD DEVICE 16
- F'RRTITI2r"l=X 16
- PARTITION 16
- RANGE LO HI Ranges: 17
- NEW NAME 18
- RM2THER? 18
- (ENTER-YES] 19
- DEVItE=XXXXXX 20
- RANGE LO HI 21
- II”)PORTII”IG 21
- Memory Limitations 23
- Layer Limitations 24
- Final Suggestions 25
- New System*MIDI Parameters 27
- ENTER-YES). YOU 28
- ENTER-YES) button. You have 28
- ENTER-YES]. The WaveSample 28
- NTER-YES) repeatedly, and 28
- BRCKUPIREST08E 29
- Please Note the Following! 30
- Caution!Caution! 30
- Sample DAT 31
- What You Need To Get Started 32
- SCSI Review 33
- DAT BACKUP 34
- Select the DAT BACKUP Command 35
- Go Ahead 35
- RECORD-ENTER 37
- COflPLETE 37
- SYSTEM STOP 38
- VERIFY,----OF 38
- DAT RESTORE 39
- DAT VERIFY 40
- User Retry 41
- COMMAND) 42
- Audio Track Recording 43
- Give It a Try! 43
- An Audio Track Tutorial 43
- Play Along with the Sequence 44
- Record Your First RAMTrack 45
- Press Play and Enjoy! 45
- Master Directly to DAT 45
- Save your Work 45
- Caution: 46
- GI’SK-HIT EMTER 47
- Infernal RAM Memory 48
- Types of Audio Tracks 49
- Song Audio Tracks 50
- All About Memory 51
- DiskTrack 53
- recording: 53
- Auditioning DiskTracks 56
- PLRYIREC=OFF 57
- 1 or 2 Inputs? 58
- INPUT+FX Signal Chain Routing 60
- MAIN-OUT Signal Chain Routing 61
- ENTER-YES) (when the 62
- Audio Tracks in “Chain Play” 63
- Which Track is Selected? 64
- Tie the Jack to the Track 64
- Overdubbing 65
- Amalgamation 66
- Audio Triaaer event: 69
- Bounce-Down 71
- Bounce-Down 72
- 240-2 Bounce-Down 72
- Notes on Bounce-down: 72
- Song Audio Track 73
- Audio Track Storage 74
- .&ution: 75
- BRNK MRIIE=RJRK JUT 76
- DELETE EL 76
- L’ERSIEN? 76
- Deleting: 79
- To Delete a RAM AudioSample: 79
- Delete a SCSI AudioSample: 79
- SRL’E GL3BRL 81
- PRRRflETERS 81
- 72 ENSONIQ 82
- New Sequencer Parameters 83
- COMMAND) will leave them 86
- New (Audio) Track Parameters 87
- RSf:PLNFI17E=RS::PL--u”CO3U 88
- RflE=‘U1‘1CEFI1”1ED* 88
- AUDIO TRACK) button) 91
- Caution:Caution: 92
- System Optimization Tips 95
- AudioSample Specs 95
- INSTRUMENT), and 97
- ENTER-YES to begin 97
- ENTER-YES), or selecting an 99
- ENTER-YES) 100
- Effect Parameters 102
- Additional Effect Parameters 116
- SP-3 SCSI Interface Manual 117
- Getting Started 118
- SCSI Terminators 119
- ~.WZllTliilg: 121
- Selecting the Storage Device 123
- ENTER-YES) 125
- Managing Disk Files 127
- Directories 128
- Directory Commands 129
- Directory Recommendations 130
- I I I I 1 130
- File Paths 131
- Bank Files 131
- Direct-MacrosTM 132
- TRACK) locations contain 135
- INSTRUMENT), and continue 137
- Limited Warranty for the SP-3 138
- What is the DI-10 Digital 139
- Interface? 139
- About the Digital Input 139
- Easy All-Digital Sampling 140
- Starting to Record 141
- Normalizing Gain 142
- Default Output Routings 142
- About the Digital Output 142
- DI-10 Appendix 143
- DI-10 Digital 144
- Glossary 145
- Version 3 Index 147
- DEFINITION 101 148
- MAIN-OUT48,61 150
- SAVE THESE INSTRUCTIONS 153
- EN50NiPI”’ 154
Produits connexes et manuels pour Pianos numériques ENSONIQ ASR-10
(9 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.549 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels