ENSONIQ ASR-10 Spécifications télécharger pdf (Page 44)

Audio Track Recording

Set-up for Recording a RAMTrack

Plug a guitar or microphone with a l/4” phone plug into the jack marked Audio Input

AlLeft on the rear panel.

Press the (AUDIO TRACK A) button. The yellow Selected LED above the button will light.

This indicates that Audio Track A is selected for editing.

Press (AUDIO TRACK A) again. The red Source-Monitor LED will light. This indicates that the

Audio Track is active or Source Monitor enabled and can be used to listen to incoming audio

from the corresponding rear panel Audio Input. The Left Audio Input corresponds to Audio

Track A and the Right Audio Input corresponds to Audio Track B.

To select an

Audio Track,

press its button:

Its yellow

Selected LED

will light

(solidly):

Press the Audio Track

button again and the red

Source Monitor LED will

button placement is different than the

keyboard ASR-10, but the functionality

If you do not hear audio when using a microphone, flip the MidLine Switch on the rear

panel of the ASR-10 (keyboard only) up to the Mic position. You should now be able to hear

the signal. However, it may still be a bit too loud or soft.

Tip:

(ASR-10 Keyboard only) You can overload the analog mic pre-amp by setting

the MidLine switch to Mic for a line-level signal source. This creates a fabulous analog

distortion for guitar (or whatever) without using the effects processor. Then use the

effects processor to add chorus, reverb, or any other effect to the analog distortion.

This can then be sampled or recorded to Audio Tracks, or you can just play along with

sequences.

To further adjust the volume, turn the Input Level Trim Control knob on the rear panel of

the unit until the signal just begins to light the red Signal/Peak indicator.

The Input Level Trim Control knob increases the signal level when turned clockwise and

decreases the signal level when turned counter-clockwise (as viewed when facing the rear

panel).

Test your guitar or microphone.

Depending on the output level of your source, you may or may not hear signal coming

through the ASR-10. The left pair of Signal/Peak Input Level indicators will light when a

signal is present (green indicates a signal is detected, and red indicates the signal has reached

6 dB below the point of overload). You should see these indicators light when you hear

audio.

Play Along with the Sequence

Now that you are set up for recording a RAMTrack, you may want to have a “practice run” to

play or sing along with the sequence before recording.

Make sure the Left Audio Track’s yellow and red LEDs are still lit. If not, press the

(AUDIO TRACK A) button until they are lit.

Press the

button.

You will now hear the

ATRK

BLUES sequence, based on the classic

12-bar

blues pattern, and

you can play/sing along with it for as long as you want.

Press (STOP-CONTINUE) to stop the sequence.

ENSONIQ ASR-10 Version 3 Operating System

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 153 154

Commentaires sur ces manuels

Pas de commentaire

ENSONIQ ASR-10 Spécifications Page 44

Commentaires sur ces manuels

Produits connexes et manuels pour Pianos numériques ENSONIQ ASR-10