ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 123)

Section 6 — Effect Parameters ASR-10 Musician’s Manual

18 Edit/Effect Parameters

EQ1 FC Range: 0 to 9999 Hz

This parameter determines the filter center frequency of the parametric in the main amp stage.

Higher values have a brighter sound.

GAIN Range: -48 to +24 dB

This parameter adjusts the amount of boost or cut applied to the main amp parametric.

EQ1 Q Range: 1 to 18

This parameter determines the width of the resonant peak of the filter center. While the Filter

center parameter determines where (at what frequency) this peak will occur, the Q setting

controls the presence of the peak.

EQ2 FC Range: 0 to 9999 Hz

This parameter determines the filter center frequency of the second parametric in the main amp

stage. Higher values have a brighter sound.

GAIN Range: -48 to +24 dB

This parameter adjusts the amount of boost or cut applied to the second main amp parametric.

EQ2 Q Range: 1 to 18

This parameter determines the width of the resonant peak of the second filter center.

LOW PASS FC Range: 2.0 to 15.0 KHz

This parameter filters out the high frequencies of the speaker. The lower the value, the less high

frequencies pass through. This speaker filter is less selective than the speaker cabinet emulation

algorithms.

MOD SRC 1 MOD SRC 2

DST 1 DST 2

MIN 1 MIN 2

MAX 1 MAX 2

These parameters are explained in detail in Section 5 — Effect Concepts.

ROM-30 GUITAR AMP 3

GUITAR AMP 3 combines an inverse expander with a bright distortion for amp lead sounds.

The inverse expander may be thought of as a compressor that amplifies all signals below the

threshold. This algorithm is good for heavy metal and hard rock guitar solos. The BUS1 and

BUS2 parameters can be routed into the effect with different Dry/Wet mixes.

The parameters available for this algorithm are:

PREAMP GAIN Range: -48 to +48 dB

This parameter adjusts the amount of boost or cut applied to the EQ’d incoming signal. Lead

sounds are obtained using high gain.

OUTPUT LEVEL Range: 0 to 99

This parameter controls the output level before the output EQ.

PRE-EQ TRIM Range: -24 to +00 dB

This parameter controls the input level to the preamp EQ to eliminate the possibility of clipping

boosted signals.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 389 390

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 123