ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 283)

Section 13 — Sequencer & Audio Track Parameters

Edit/Seq•Song Parameters 1

The following parameters control the ASR-10 sequencer. Parameters for creating and

manipulating sequences, the song, and the tracks contained within each are covered here. This

section also describes the Audio Track Edit/Track parameters. For a basic overview of the

concepts involved, refer to the previous section.

The Edit/Seq•Song Page

This page acts as the main “control panel” for sequencing.

EDIT

CURRENT SEQUENCE/SONG - BAR - BEAT/STEP

SEQ•SONG

Press Edit / Seq•Song / 0 (for Current Seq/Song) 1 (for Bar)

Current Sequence/Song

EDIT

SEQ

STOP

Current

Sequence

Bar and Beat Location

within current Sequence

This screen is where you select a sequence or the song. With the selected sequence or song name

underlined (as shown above), use the Up/Down Arrow buttons or the Data Entry Slider to select

a different sequence or song.

Tip: You can always get back to the Current Sequence/Song screen by double-clicking the Seq•Song

button (when in Edit mode).

BAR/STEP — The GOTO Function

• Press the Right Arrow button to move the cursor to the BAR parameter. The display reads as

follows:

EDIT

SEQ

STOP

SEQUENCENAME BAR=001.01

This parameter shows the current location in the selected sequence or song. When the cursor is

under the Bar, Beat (or Step) Number, you can use the GOTO function to “go to” any location

within the sequence or song, by moving the Data Entry Slider or the Up/Down Arrow buttons to

select a new location, then pressing Enter•Yes. Pressing Play will always start the sequencer

from the beginning of the selected sequence. Pressing the Stop•Continue button will begin

playing the sequence from the selected bar.

Tip: After using the GOTO function to go to a certain Bar, Beat (or Step) location, pressing Enter•Yes

twice with the cursor under the Bar, Beat (or Step) value will relocate the sequencer to the last

selected GOTO location.

1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 389 390

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 283