ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 320)

Section 14 — Storage ASR-10 Musician’s Manual

10 Sequencer Data Storage

Saving a Single Sequence to Disk

Use the SAVE CURRENT SEQUENCE command to save a single sequence.

• On the Edit/Seq•Song page, select the sequence you want to save.

• Insert a formatted disk into the drive.

• Press Command, then press Seq•Song.

• Press the Left or Right Arrow button until the display reads SAVE CURRENT SEQUENCE.

• Press Enter•Yes.

• Edit the Sequence Name (if needed):

SEQ

STOP

CMD

The display shows the current name of the sequence, with a cursor (underline) beneath the first

character. If you want to give the sequence a new name, do so at this time. Use the Data Entry

Slider or the Up/Down Arrow buttons to change the underlined character, then press the

Left/Right Arrow buttons to move the underline. Repeat until the display shows the name you

want (if you don’t need to rename the sequence, just skip this step).

• Press Enter•Yes. The display will read SAVING <FILE NAME> while the sequence is being

saved.

• If there is already a sequence file with the same name on the disk, the display will ask DELETE

OLD VERSION? Press Enter•Yes to save the sequence, replacing the one on the disk. Or

press Cancel•No to abort the procedure.

• If there is not enough free space on the disk, the display will say NOT ENOUGH DISK

SPACE. Save the sequence to another disk (or delete some files from the disk).

• If you try to SAVE CURRENT SEQUENCE while the song is selected, the ASR-10 will not

execute the command, responding USE SAVE SONG + ALL. Again, make sure the sequence

is selected before trying to save it.

1 2 ... 315 316 317 318 319 320 321 322 323 324 325 ... 389 390

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 320