ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 192)

Section 10 — Wave Data Parameters ASR-10 Musician’s Manual

12 Command/Wave Page

Note: When STEREO LAYER LINK= ON, this command will be simultaneously performed on the

corresponding WaveSample in the companion layer.

CMD

SYNTHESIZED LOOP

WAVE

Press Command / Wave / scroll using the arrow buttons

This is the looping algorithm to use when all other looping techniques have failed to make a

smooth loop. Unlike the other looping algorithms, the “synth loop” uses a certain amount of

random data processing. It’s a “loop anything” algorithm, which works well with special effects.

With the SMOOTHNESS parameter, the smoother the loop, the more processes the ASR-10 goes

through to create the synth loop. For example, if you do synth loop on a voice sample, and the

SMOOTHNESS is set to very coarse, it may create a loop that sounds irregular or nervous. At the

other extreme, if the setting is too fine, it may sound metallic. The default values are the same as

in the CROSS FADE LOOP command. Manual values: FADE ZONE=1% to 99%.

SMOOTHNESS=Very Fine to Very Coarse.

LE WEWS

loop data after

randomizing

using fade cone

SYNTHESIZED LOOP

FINAL RESULT:

merge data

xfade zone

fade cone

• Select SYNTHESIZED LOOP. Press Enter•Yes.

• The display reads USE DEFAULT VALUES? Press Enter•Yes.

• The display reads KEEP=OLD NEW. Press Enter•Yes.

• Pressing Cancel•No in response to USE DEFAULT VALUES, prompts the ASR-10 to display

the manual values for this command. Use the Left/Right Arrow buttons to scroll to select:

FADE ZONE (PERCENT)=##, and SMOOTHNESS=VERY FINE, FINE, MEDIUM, COARSE,

VERY COARSE. Press Enter•Yes.

• The display reads KEEP=OLD NEW. Press Enter•Yes to complete the command (or

Cancel•No to keep the original).

Tip: If you’ve done all you can to create a smooth sounding loop, and there are still irregular volume

changes, try setting LOOP START and LOOP END (on the Edit/Wave page) to different values ,

and redoing this command.

Note: When STEREO LAYER LINK= ON, this command will be simultaneously performed on the

corresponding WaveSample in the companion layer.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 389 390

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 192