ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 96)

Section 5 — Effect Concepts

Selecting Effects 11

Selectable Effect Modulation Parameters

Most of the effects allow real-time control of selectable parameters and share common

modulation control parameters. Within these effects, each Effect Variation can have two different

Modulation Sources, Destination parameters, and defined modulation ranges (for a total of eight

different modulatable parameters). The Modulation Control Parameters are always the last eight

parameters on the Edit/Effect page:

• MOD SRC 1 — Modulation Source 1

• MOD SRC 2 — Modulation Source 2

Sources: WHEEL, PBEND, PRESS, PEDAL, XCTRL, KBD, VEL, KEYDN, SUSTN, FSW-L,

PATCH, or OFF

These parameters select the modulation sources used to modulate the parameter Destinations.

Each Effect Variation has a choice of two discrete mod sources.

• DST 1 — Mod1 Destination Parameter

• DST 2 — Mod2 Destination Parameter

Ranges: various (selected parameter name)

The Destination parameters select which effect parameters will be modulated by the modulation

sources. The choice of parameters varies depending on the selected effect. Any parameter within

an algorithm can be selected. Each Effect Variation has a choice of two different mod

destinations.

Tip: Once the destination has been defined, you can toggle between the DST (Destination) parameters

and the actual parameter that is selected to be modulated, by alternate presses of the Enter•Yes

button. When the parameter being modulated is displayed, you can watch the actual value

change as the mod source output changes. You cannot edit a parameter when it is assigned as a

modulator destination. Disabling modulation of a parameter will restore its saved value.

• MIN 1 — Mod 1 Param Range Minimum

• MAX1 — Mod 1 Param Range Maximum

• MIN 2 — Mod 2 Param Range Minimum

• MAX2 — Mod 2 Param Range Maximum

Ranges: 0 to 99

These four parameters set the minimum and maximum amount (based on a percentage of the

selected parameter’s range) that the Mod Destination will be modulated by the Mod Source.

Inverting the amounts will also invert the Mod effect.

Remember

In order for the effect modulation to work, the EFFECT MOD CONTROL parameter on the

Edit/Track page must be set to ON for the selected Instrument•Sequence Track.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 389 390

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 96