ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 182)

Section 10 — Wave Data Parameters ASR-10 Musician’s Manual

2 Edit/Wave Page

Once you have gotten close using the percent setting, press the Left Arrow button to underline

the Fine Adjust setting. Now the Data Entry Slider or the Up/Down Arrow buttons will move

the SAMPLE START in small steps (less than 1%), letting you fine-tune its exact position while

playing the sample.

EDIT

SAMPLE END

WAVE

Press Edit / Wave / 2

This parameter allows you to set the sample end point. Again you see the sample number (Fine

Adjust) and the percent (Coarse Adjust). Use the data entry controls to edit this parameter in the

same fashion as the SAMPLE START parameter.

Loop Parameters

The LOOPSTART, LOOPEND, and LOOPPOS parameters all provide both Coarse and Fine

Adjust values for adjusting the position of the loop.

EDIT

LOOPSTART

WAVE

Press Edit / Wave / 3

This parameter allows you to set the loop start point. After making a sample it is often necessary

to “loop” (play over and over) a portion of the sound, so that it can sustain indefinitely when the

key is held down. Getting a good loop tends to be the most difficult part of sampling.

Here are a few steps to get you started once you have sampled a sound that you want to loop:

• Turn ON the AUTO-LOOP FINDING parameter on the Edit/System•MIDI page:

Press Edit, then System•MIDI, then scroll left to the parameter AUTO-LOOP FINDING.

Make sure it is ON. When AUTO-LOOP FINDING=ON, every time you move the LOOP

START or LOOP END points of a WaveSample, the ASR-10 picks only “optimized” loop

points – ones most likely to work.

• On the Edit/Wave page, the MODE parameter determines whether the WaveSample will loop

(among other things). Set it to MODE=LOOP FORWARD.

• Select the LOOP START parameter.

Move the cursor to underline the Loop Start Percent value (the number in parentheses). While

holding down a note, move it away from the beginning of the WaveSample (the 25% to 50%

range is usually a good starting point).

LOOP START is used in conjunction with the next parameter.

EDIT

LOOPEND

WAVE

Press Edit / Wave / 4

This parameter allows you to set or change the loop end point. In addition to the Coarse and

Fine Adjust values, the LOOPEND parameter also provides a fractional value (the number after

the decimal point) that adjusts the end point of the loop by 1/16ths of a sample. This is especially

helpful for fine-tuning short loops.

Move the cursor to underline the Loop End Percent value (in parentheses) and move it towards

the beginning of the WaveSample, using the data entry controls to adjust in the same fashion as

the LOOP START parameter. Move the LOOP START and the LOOP END around until you find

the best sounding loop.

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 389 390

Commentaires sur ces manuels

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 182

Commentaires sur ces manuels

Produits connexes et manuels pour Pianos numériques ENSONIQ ASR-10