ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 206)

Section 11 — WaveSample and Layer Parameters

Pitch Commands 3

instrument to use the pitch table that you want to edit (with the PITCH TBL parameter on the

Edit/Layer page), and then invoke the pitch table command. If you’re editing an existing

pitch table, the CREATE NEW PITCH TBL prompt will not appear.

• Press Enter•Yes. The display reads KEY E4 = * 0 CENTS. This is the default display. If you

press any key on the keyboard the display will change. Pressing Cancel•No will abort this

command.

• Press Middle C on the keyboard. The display now looks like this:

Fine TuneSource Key

PITCH

KEY C4 = C4 0 CENTS

Playback Pitch

CMD

The source key can be thought of as the physical location of the key on the keyboard. The

playback pitch can be the same as the source key—as shown in the display—or it can be any pitch

from A0 to C8. The range of the fine tune is 0 to 99 cents. This allows you to create micro-

tunings. Here’s how:

• Play C4+ on the keyboard (the source key), or use the Up/Down Arrow buttons or the Data

Entry Slider to select the source key.

• Press the Right Arrow button twice to move the cursor under the Fine Tune value, and change

it to

CENTS.

Fine TuneSource Key

PITCH

KEY C+4 = C+4 50 CENTS

Playback Pitch

CMD

You have just defined a new interval between C and C4+. The interval has now been stretched

by 50 cents. You can now repeat this procedure for each key on the keyboard to create your own

custom pitch table.

Press the Right Arrow button until the display shows TBL NAME= PITCHTABLE 1 (the default

pitch table name). You can name your custom pitch table using the Left/Right Arrow buttons to

move the cursor, and the Data Entry Slider or the Up/Down Arrow buttons to select the

characters. After you’ve named your custom pitch table:

• Press Enter•Yes to exit EDIT PITCH TABLE.

Note: For the following commands, you can’t COPY, DELETE, or EXTRAPOLATE the STANDARD or

NO PITCH pitch tables. If you try, the NO EDIT PITCH TABLE message will be displayed. You

must create a new pitch table first using the EDIT PITCH TABLE command.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 389 390

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 206