ENSONIQ ASR-10 Manuel d'instructions Page 94

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 390
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 93
Section 5 — Effect Concepts
Selecting Effects 9
Triple Function Effect Mixer
AUX 1
L
R
Output Expander
L
R
Output Expander
L
R
Output Expander
AUX 3
AUX 2
Pan
L
R
L
R
Effect 2
BUS1
BUS2
BUS1
BUS2
Voice Output
Main
Outputs
Effect 1
Vol
BUS3
Destination Bus
Effect 3
BUS3
Some effects, such as DIST+CHO+REV, use the above mixing scheme. Effect 1 and Effect 2
usually have a Dry/Wet mix within them. This mixer can be configured as three independent
effects, or three effects in a series.
Performance Control of Tracks When Using Bank Effects
When using a Bank Effect, all the instruments in the internal memory are always routed through
the same global effect. In order to gain some individual control for each instrument, two
parameters on the Edit/Track page determine how each instrument will interact with the Bank
Effect.
OUT — This parameter determines which of the Busses the instrument will be sent through.
The options are: WAVESAMPLE, BUS1, BUS2, BUS3, AUX1, AUX2, and AUX3. By using this
parameter you can give individual instruments different Dry/Wet or multiple effect mixes.
The WAVESAMPLE output bus is not available for Audio Tracks.
EFFECT MOD CONTROL — This parameter determines whether the controllers of a
particular instrument will be routed to control the effect. This is an important setting when
using a Bank Effect: since all instruments are routed through the same effect, it could be
confusing to have multiple instruments sending conflicting controller information to the effect.
Vue de la page 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 389 390

Commentaires sur ces manuels

Pas de commentaire