ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 130)

Section 6 — Effect Parameters

Edit/Effect Parameters 25

ROM-35 EQ+FLNGR+DDL

EQ+FLNGR+DDL combines an EQ with a flanger and a digital delay. Use flanging to get that

“jet aircraft woosh” effect.

EQ+FLANGER+DDL Signal Routing

BUS1 Left

BUS2 Left

BUS1 Right

BUS2 Right

Main

Outputs

EchoDelay

Flanger

Echo

Level

Input Level Trim

Delay

Feedback

In this algorithm the signal enters an input level trim (EQ TRIM) followed by a programmable

EQ, and then is routed to the flanger. The flanger is routed directly to the output. The left

channel signal passes through the delay and is routed back into the flanger. Another signal from

the delay is routed to the output on the right side. The DELAY FEEDBACK parameter controls

both delay levels. There are two discrete echoes that are sent to the left and right outputs

respectively. The signal from both echoes has one level control (ECHO LEVEL). There is also an

external dry signal (not shown) that goes directly from the input to the output (BUS3). The BUS1

and BUS2 MIX parameters can be routed into the effect with different Dry/Wet mixes.

The parameters available for this algorithm are:

FLANGE RATE Range: 0 to 99

This parameter controls the rate of modulation of the flanger effect.

WIDTH Range: 0 to 99

This parameter controls the range of the high to low frequency sweep in the flanger effect.

FLANGE CENTER Range: 0 to 99

This parameter controls the sweep center of the flanger effect. The larger the flanger center, the

wider will be the available width.

FLANGE FEEDBACK Range: -99 to +99

This parameter controls the amount of feedback applied from the output to the flanger input.

The sign of the value determines the polarity of the feedback.

NOTCH DEPTH Range: -99 to +99

This parameter controls the depth of the notches created by the flanging effect. A setting of +0

will disable the flanging effect. A setting of +0 will also provide a doppler effect for wide

moderately slow LFO rates.

L/R LFO Range: OUT-OF-PHASE or IN-PHASE

This parameter determines whether the flanger on the left and right channels is modulating IN-

PHASE or OUT-OF-PHASE.

SAMPLE/HOLD RATE Range: 0 to 100

This parameter controls the sample rate of a sample and hold network. This is applied to the

LFO within the flanger. When in hold, the effect will be to create momentarily fixed notches

within the frequency spectrum (if the notch depth is not +0). A setting of 1 will have the largest

space between samples. Higher values will increase the number of holds per second, making the

flanging flow more smoothly. The sample and hold function can be turned off (when set to 0).

DLY TIME L Range: 0 to 1500 ms

This parameter controls the time delay for the left channel regen delay. This is the “ping.”

DLY TIME R Range: 0 to 1500 ms

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 389 390

Commentaires sur ces manuels

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 130

Commentaires sur ces manuels

Produits connexes et manuels pour Pianos numériques ENSONIQ ASR-10