ENSONIQ ASR-10 Manuel d'instructions télécharger pdf (Page 141)

Section 6 — Effect Parameters ASR-10 Musician’s Manual

36 Edit/Effect Parameters

The parameters available for this algorithm are:

COMP GAIN Range: -48 to +48 dB

This parameter boosts the compressed signal level.

COMP RATIO Range: 1/1 to 40/1, infinity

This parameter sets the amount of compression. The range is based on decibels (dB) above the

threshold. If this is set to 4/1 for example, it will compress changes in signals above the

threshold by one quarter. When this is set to infinity, it acts as a limiter.

COMP THRESHOLD Range: -96 to +0 dB

This parameter sets the threshold level. Signals that exceed this level will be compressed, while

signals that are below will be unaffected. To turn off the compressor, set the level to +0 dB.

COMP ATTACK Range: 50µs to 100ms

This parameter determines the attack rate after the initial signal has been detected and before the

compression takes affect.

COMP RELEASE Range: 1ms to 10.0s

This parameter determines how long it takes for the compression to be fully deactivated after the

input signal drops below the threshold level. This is generally chosen longer than the attack

time.

GATE OFF Range: -96 to +0 dB

This parameter sets the lower threshold level at which the noise gate shuts off the audio.

GATE ON Range: -96 to +0 dB

This parameter sets the upper threshold level at which the noise gate passes audio. This higher

second threshold prevents false “turn ons.”

GATE RELEASE Range: 1ms to 10.0s

This parameter determines how long it takes for the gate to be fully released after the input signal

drops below the threshold level. Lower settings yield a quick gate.

BASS FC Range: 0 to 1000 Hz

This parameter sets the cutoff frequency of the lower frequency band shelving filter.

GAIN Range: -48 to +24 dB

This parameter sets the amount of boost or cut applied to the low shelving filter.

TREBLE FC Range: 1KHz to 15KHz

This parameter sets the cutoff frequency of the upper frequency band high shelving filter.

GAIN Range: -48 to +24 dB

This parameter sets the amount of boost or cut applied to the high shelving filter.

EQ TRIM Range: -24 to +0 dB

This parameter allows you to adjust the input volume of the EQs, to eliminate the possibility of

clipping boosted signals.

MOD SRC 1 MOD SRC 2

DST 1 DST 2

MIN 1 MIN 2

MAX 1 MAX 2

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 389 390

Pas de commentaire

ENSONIQ ASR-10 Manuel d'instructions Page 141